Here’s what they look like after being “modified”:

Bunker_j_behind

Bunker_j_front

Tablebunkerlookingout_big

All it takes to do something like this is an old picnic table and some tools like a hatchet, a ratchet, a hammer, and a sledge hammer….and a shovel most definitely.

So here’s what you do: You get the table positioned how you want it, then you gotta get to work taking the slats off of the seat on one side(the side you’ll be getting into the bunker on). Then you’ll want to position those slats to cover the opening in the front of the bunker like in the pictures above. If you want you can dig them out to give you a lot more room like I did but it’s not completely neccessary. All it takes is a 3 foot wide hole that extends under the bench about 3 feet and goes 3 feet down. You’ll want to taper it out the back though.